Holybro Pixhawk 6C Aluminum Case + PM02 V3 Power Module

The Pixhawk 6C FC combined with the PM02 V3 12S Power Module brings tons of power to the autopilot and makes it super easy to power the multirotor. 

Pixhawk 6C Flight Controller Module

The Pixhawk® 6C is the latest update to the successful family of Pixhawk® flight controllers, based on the Pixhawk® FMUv6C Open Standard and Connector Standard. It comes with PX4 Autopilot® pre-installed. Inside the Pixhawk® 6C, you can find a STMicroelectronics® based STM32H743, paired with sensor technology from Bosch® & InvenSense®, giving you flexibility and reliability for controlling any autonomous vehicle, suitable for both academic and commercial applications.

The Pixhawk® 6C's H7 microcontroller contains the Arm® Cortex®-M7 core running up to 480 MHz and has 2MB flash memory and 1MB RAM. Thanks to the updated processing power, developers can be more productive and efficient with their development work, allowing for complex algorithms and models. The FMUv6C open standard includes high-performance, low-noise IMUs on board, designed to be cost-effective while having IMU redundancy. A vibration isolation System to filter out high-frequency vibration and reduce noise to ensure accurate readings, allowing vehicles to reach better overall flight performances.

The Pixhawk® 6C is perfect for developers at corporate research labs, startups, academics (research, professors, students), and commercial applications.

PM02 V3 12S Power Module 

PM02 Power Module is a simple way of providing your autopilot flight controller with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The onboard switching regulator outputs 5.2V and a maximum of 3A from up to a 12S LiPo battery. The Power Module comes completely assembled with XT60 connectors, and wrapped in shrink tubing for protection.

The Power Module is designed to power an autopilot flight controller, an RC receiver, and APM accessories (GPS, radio). It is not designed to power servos. Use your aircraft's own ESC/BEC for that.

The GH terminal is also compatible with Pix32, Pixhawk4, Pixhawk4 mini, Pix32v5, and Durandal.

Pixhawk 6C Flight Controller Module

•  High-performance H7 Processor with clock speed up to 480 MHz
• New cost-effective design with the low-profile form factor
• Redundant inertial measurement unit (IMU) from Bosch® & InvenSense®
• Newly designed integrated vibration isolation system to filter out high-frequency vibration and reduce noise to ensure accurate readings
• IMUs are temperature-controlled by onboard heating resistors, allowing the optimum working temperature of IMUs

PM02 V3-12S Power Module

• UBEC input voltage : 7~51v (2~12s LiPo) 
• Rated current:60A
• Max current:120A(<60S)
• Max current sensing: 120A
• Supports 12S battery
• Voltage and current measurement configured for 3.3V ADC 
• The switching regulator outputs 5.2V and 3A max 
• Weight: 20g

 

•  Support Software

• 1 x Pixhawk 6C Flight Controller Module
• 1 x PM02 V3 12S Power Module 
• 1 x Cable Set