The Lumenier LUX HD AIO AM32 F7 Flight Controller and ESC is DJI HD system ready with an onboard 10v regulator to power the DJI Air Unit in a simple plug-and-play configuration.
About this Product
The Lumenier LUX HD AIO AM32 F7 Flight Controller + ESC is DJI HD system ready with an onboard 10v regulator for simple plug-and-play configuration. It uses a powerful F7 processor along with top-of-the-line hardware from the 50A AM32 2-6s powered by 4x F4 processors! Unleash the capabilities of your FPV Racing Quadcopter with the Lumenier LUX HD AIO F7 Flight Controller! This LUX HD AIO F7 comes in a standard 30.5x3.5 form factor weighing only 15g.
The LUX HD AIO F7 builds on all the best features of its predecessors and further improves on hardware components and layout, and is now dedicated to a design for the DJI digital HD system.
You get 6x dedicated UART ports with built-in inversion for peripherals. This Flight Controller features 1 onboard LC VBAT filtered power pad designed to power your DJI Air Unit at 10v and also other 5v accessories. The onboard 5v 3A regulator can be used to power the camera, Rx, and LEDs all at the same time, while the dedicated 10v 2A regulator reliably can power a DJI system.
Features
- Supports DSHOT 1200, Proshot, Oneshot125 (125-250us), Oneshot42(41.7-83.3us), and Multishot (5-25us). Auto-detection
- Synchronous rectification technology adds efficiency, damped light
- Adaptive timing, compatible with a wide range of motors and Kv
- Built-in 5v regulator that powers the LED system
- Powerful regenerative braking / active braking
- Anti-Vibration silicone grommets
- MCU: 216MHz STM32F722RET6
- 6 Uarts with built-in inversion
- 2-6s LiPo battery compatible
- Input: 8.4~36V (2~6S LiPo)
- WS2812 Led Strip support
- BEC: 10v 2A cont. (for DJI)
- Beeper solder pad
- BEC: 5V 3A cont
- LC Power Filter
- IMU: MPU6000
Software/Hardware Features
- AM32 passthrough flashing supported by hardware
- Betaflight support - target LUXAIO
- Firmware: AM32 (LUXAIO)
- Direct Plug and Play
Specifications
- Mounting Holes: 30.5mm square to the center of holes
- Dimensions: 38x38x5mm (includes USB in height)
- USB C connector for programming
- PCB: High-quality, gold-plated
- Dimensions: 39x45x5mm
- Constant: 50 Amps
- Input: 2-6s LiPo
- Burst: 60 Amps
- Gyro: BMI270
- Weight: 15g
Includes
- 4x Anti-Vibration Silicone Grommets (for M3-sized screws)
- 1x Lumenier LUX HD AIO F7 FC + 50A AM32 2-6S ESC
- 1x 8pin (5 wire) Micro JST-GH 8cm Connector
- 1x Hardware Kit
More information
| SKU | 22321 |
|---|---|
| UPC (GTIN) | 724376363834 |
