Lumenier RID - Remote ID Module

The Lumenier RID complies with FAA regulations and features an integrated UBLOX SAM-M10Q for precise positioning. Its Bluetooth 4 and 5 broadcast transmitter and reverse polarity protection ensure seamless connectivity and safety. Equipped with an onboard magnetometer, efficient power design, and a red/green LED status indicator, it offers reliable performance for drone enthusiasts and professionals alike. The GPS and magnetometer data can be used at the same time by a flight controller for autopilot functionality and OSD information. Each module is individually tested and verified and includes a test report.

• Bluetooth 4 and 5 broadcast transmitter module with integrated antenna
• The onboard connector uses "Basic GPS" pinout from Pixhawk standard
• Functions as a GPS/Mag data source as well for the Flight Controller
• Efficient power design with a wide voltage range of 5-34V (2s-8s)
• Integrated UBLOX SAM-M10Q GPS
• Meets FAA remote ID requirements
• 3.3V Logic levels - ESD-protected
• Onboard LIS3MDL magnetometer
• Red/Green LED status indicator
• Individual test report included
• Reverse Polarity Protection

• Broadcast Transmitter Module: Bluetooth 4 and 5 (with integrated antenna)
• GPS: Integrated UBLOX SAM-M10Q
• Onboard Magnetometer: LIS3MDL
• Logic Levels: 3.3V (ESD-protected)
• Magnetometer I2C Address: 0x1E
• Reverse Polarity Protection: Yes
• Voltage Range: 5-34V (2-8S)
• Lightweight 9g
• Size: 32.5x16.5x10.5mm

IMPORTANT NOTES

• Onboard connector uses "Basic GPS" pinout from Pixhawk standard
• Red/Green LED status indicator 
  
  • Flashes RED on boot until a fix is detected, then flashes green.
  • The RID Bluetooth functionality is still active without a fix; it just sends "unknown location" data. 
• Use Caution. If the board is not in heat shrink and sits on a conductive surface across these two points, it will short out the battery and could cause damage.