RadioMaster RP2 V2 ExpressLRS 2.4GHz Nano Receiver w/ Fixed SMT Antenna
The RadioMaster RP2 V2 ExpressLRS 2.4ghz Nano Receiver w/ Fixed SMT Antenna is an open-source receiver based on ExpressLRS.
About this Product
The RadioMaster RP2 V2 ExpressLRS 2.4ghz Nano Receiver w/ Fixed SMT Antenna is an open-source receiver based on ExpressLRS. It features an ESP8285 MCU and an SX1281 RF chip. The RP2 V2 has a built-in ceramic antenna which is super light and small in size and ideal for racing. The RP2 V2 features WIFI built in so you can upgrade firmware by WIFI and configure the Receiver via the built-in WebUI with your PC or mobile phone. Due to the low-latency and high-refresh-rate RF module, the RP2 V2 is ideal for FPV racing or long-range flights. Suitable for whoops, drones, and fixed-wing models due to the ultra-light and Nano size, these receivers can fit just about anywhere!
Features
- Improved PCB Design
- Improved Solder Pads
- Wide Compatibility
- Built-in TCXO
- Top-Side LED
Specifications
- Maximum Receive Refresh Rate: 500Hz / F1000Hz
- Firmware Version: ExpressLRS v2.4 pre-installed
- Item: RP2 V2 Nano ExpressLRS 2.4GHz Receiver
- FW Target: RadioMaster RP1/2 2400 RX
- Minimum Receiver Refresh Rate: 25Hz
- Frequency Range: 2.404 - 2.479 GHz
- Antenna: 65mm 2.4GHz T Antenna
- Dimension: 13mm x 11mm x 7mm
- Weight: 0.55g (On Board antenna)
- Antenna: On Board SMT Antenna
- Telemetry RF Power: 10mW
- RF Chip: SEMTECH SX1281
- Working Voltage: 5V
- Bus Interface: CRSF
- MCU: EPS8285
- Type: ISM
Includes
- 1x RadioMaster RP2 V2 ExpressLRS 2.4ghz Nano Receiver w/ Fixed SMT Antenna
- 1x User Manual
- 1x CRSF Wire
More information
| SKU | 19363 |
|---|---|
| UPC (GTIN) | 764613353129 |
