CubePilot Cube Purple

CubePilot Cube Purple (also known as Cube Mini) is an autopilot system designed specifically for land-based applications such as boats, cars, or rovers. This flight controller is based on the original Pixhawk 2.1 Cube Black main module, featuring an F4 chip, but offers a smaller platform suitable for situations where sensor redundancy isn't necessary. The Cube Purple Set, which includes a Mini Carrier board, serves as an optimal solution for compact drones. Moreover, it is compatible with both PX4 and APM firmware.

• 80-pin DF17 connector
• Built-in STM32F4 chip
• Single Baro Sensor
• Single IMU sensor
  
  

PROCESSOR

• 32-bit ARM Cortex M4 core with FPU
• 168 Mhz/256 KB RAM/2 MB Flash
• 32-bit failsafe co-processor

SENSORS

• InvenSense MPU9250 (accel and gyro) * 1
• IMU (accels, gyros, and compass) * 1
• MS5611 barometers * 1

INSIDE THE CUBE

• An STM32F100 I/O processor with pass-through capabilities for failsafe. (deals with the Receiver and outputs )
• An STM32F427 Rev 3 Flight management unit. (where the flight controller lives.)
  
  

IMPORTANT NOTES

• Please remember to install the firmware below!

• Firmware

• 1x CubePilot Cube Purple