Holybro Pixhawk PM07 14S Power Module

This PM07 Power Module supplies clean 5.2V to flight controller from the battery and provides current consumption and battery voltage measurements via analog signal through a 6 Pin JST-GH cable, along with integrated esc power & signal distribution for up to 8 ESCs.

PM07 has two 5.2V power output port that can provide redundant power to the flight controller, with independent circuits, BEC IC and circuitry.

It is also great for flight controller that do not have built-in servo header pins like the Pixhawk 6C & Pixhawk 4. It comes with pre-soldered wires, capacitor, and XT60 connector.

Note: This PM07 Power Module uses analog data output and is not compatible to the Pixhawk 5X (Requires a digital PM like PM02D).

• The PM board serves the purpose of a Power Module, as well as a PDB
• Provides regulated power to Pixhawk 4 and ESCs
• Sends information to the autopilot about battery's voltage and current supplied to the FCs and the motors.

• Input voltage: 2S-14S
• PCB Cont. Current Rating: 90A
• PCB Burst Current Rating: 140A (<60 Sec)
• Output: DC 5.2V & 3A Max 
• Voltage Divider: 18.182
• Amperes per Volt: 36.364
• Dimensions:68*50*10 mm
• Mounting Holes:45*45mm
• Weight: 43.8g

IMPORTANT NOTES

Make the PM07 show the quantity of electric charge of your battery

Mission Planner setup:

1. Connect PM07 to the battery, and also connect it to Mission Planner via USB.
2. Click INITIAL SETUP and come to the menu Battery Monitor.
3. Make Monito into Analog Voltage and Current.
4. Make Sensor into 9: Holybro Pixhawk4 PM.
5. Make HW Ver: "The Cube or Pixhawk"  
           HW Ver:  Durandal           
6. Input 18.182 into Voltage divider (Calced).
7. Input 36.364 into Amperes per volt.
8. Disconnect and reconnect it to finish the setup. Measured battery voltage shows the current quantity of electric charge of the battery.

• 1x PM07 board
• 1x 80mm XT60 connector wire (installed)
• 1x Electrolytic capacitor: 220uF 63V (installed)
• 2x JST GH 10P Cable
• 1x JST GH 8P Cable
• 2x JST GH 6P Cable