Holybro PM08D Power Module - 200A 14S

This Holybro PM08D 14S, 200A Power Module supply provides regulated 5.2V to the flight controller from the battery while also providing current consumption and battery voltage measurements to the flight controller.

The Power Module has two 5.2V power output ports with independent circuits, BEC IC, and circuitry that can provide redundant power to the flight controller.

Designed for vehicles with high power requirements, this power module comes housed in an aluminum heatsink case with a fan, protecting the module from external elements and actively dissipating heat generated during operation to ensure durability and optimal performance.

• Aluminum Case for Heat Dissipation
• 200A Continuous Current Rating
• Supports 2S - 14S Battery
• Easy to Set Up

• 5V BEC Connector Type: Molex CLIK-Mate 2mm 6-Pin
• PCB Burst Current Rating: 1000A (<1 Sec @ 25°C)
• PCB Continuous Current Rating: 200A
• Mounting Hole: 79mm * 38.1mm
• Output: DC 5.1-5.3V & 3A Max
• Max Current Sensing: 237.6A
• Power Monitor Chip: INA228
• Dimensions: 101 * 45 * 26mm
• Input Voltage: 2S-14S
• Weight: 151g

IMPORTANT NOTES

• This PM uses I2C digital signal data output and is compatible with Pixhawk 5X/6X or other FMUv5x/6x Autopilots. It is NOT compatible with flight controllers that use analog PM such as the Pixhawk 6C & Mini, Pixhawk4 & Mini, pix32 v5, or Durandal flight controllers.
• This digital power module is only compatible with wire and connector sold separately.
• PM08D is supported by PX4. For Ardupilot, it is supported in version 4.4 and later.

• 2x Molex CLIK-Mate 2.0mm 6-Pin Cable, 15 cm
• 1x Holybro PM08D 14S, 200A Power Module
• 4x Sets of Screws, Washers, and Nuts
• 1x 40x40mm Fan