Holybro SiK Telemetry Radio V3 (2pcs) - 500mW 915MHz

This Holybro SiK Telemetry V3 Radio is a small, light, and inexpensive open-source radio platform that typically allows ranges of better than 300m “out of the box” (the range can be extended to several kilometers using a patch antenna on the ground). This radio is plug-and-play for all Pixhawk Standard and other Flight controllers, providing the easiest way to connect telemetry between your autopilot and a ground station. It uses open-source firmware specially designed to work well with MAVLink packets and to be integrated with the Mission Planner, Ardupilot, QGroundControl, and PX4 Autopilot. 

• Error correction corrects up to 25% of bit errors. Open-source SIK firmware
• 2-way full-duplex communication through adaptive TDM UART interface
• Configurable through Mission Planner & APM Planner
• Plug-n-play for Pixhawk Standard Flight Controllers
• Connect your Autopilot and Ground Station easily
• Micro-USB port (Type-C Adapter Cable Included)
• Interchangeable air and ground radio
• 6-position JST-GH connector
• Open-source SIK firmware

• Maximum output power (adjustable): 500 mW  -117 dBm receive sensitivity
• Configurable duty cycle: Frequency Hopping Spread Spectrum (FHSS) 
• Electrical Data:
  
  • Supply voltage: 5V DC (from USB or JST-GH)
  • Transmit current: 100 mA at 20dBm
  • Serial interface: 3.3 V UART
  • Receive current: 25 mA
• Dimensions: 28 x 53 x 10.7mm (without antenna)
• FT230X/FT231: USB to BASIC UART IC
• FCC IDENTIFIER: 2AP22-HT03-V3
• Protocol framing: MAVLink 
• Serial link: Transparent 
• Connector: RP-SMA

• Telemetry-Radio-V3-Quick-Start-Guide

• 2x Holybro SiK Telemetry Radio V3 - 500mW/915MHz w/ Antennas
• 1x JST-GH-6P to Molex DF13 6P (for Pix32, Pixhawk 2.4.6, etc.)
• 1x JST-GH-6P to JST-GH-6P cable (for Pixhawk Standard FC)
• 1x Micro-USB to Micro-USB OTG adapter cable
• 1x Micro USB to Type C Adapter
• 1x Micro-USB to USB-A cable